NETGEAR SXS80 User Manual page 206

Step 4. Sync an add-on satellite to the router (optional)
If you want to extend your WiFi coverage, you can purchase an Orbi Pro WiFi 6 satellite (model SXS80) separately. The
To sync an add-on Orbi Pro WiFi 6 satellite:
1. Place the satellite approximately 10 ft. away from the router, facing the router, with a direct line of sight.
2. Connect the satellite to a power source.
The power LED on the back of the satellite lights green.
After approximately two minutes, the satellite bar LED on the front of the satellite lights solid white.
3. Press the Sync button on the back of the satellite, and within two minutes, press the Sync buttton on the back of the
router.
The satellite bar LED pulses white, and then lights blue.
If the bar LED lights amber or magenta, see
Step 5. Place the satellite at the desired location (optional)
Place the Orbi Pro WiFi 6 satellite at the location where you want WiFi coverage. The satellite must be within range of the
router or another Orbi Pro satellite that is connected to the router. The router supports a maximum of six satellites.
installations see https://kb.netgear.com/000045858/.
To place your Orbi Pro WiFi 6 satellite:
1. Place the satellite in the desired location.
2.
If the satellite bar LED lights amber, indicating that the connection is fair but not good, consider moving the satellite
closer to the router.
3. If adding more than one satellite, repeat steps 1 and 2 of this procedure.
4.
For more information, see
Satellite bar LED sync
Prepare the wall mount
information.
https://kb.netgear.com/31029, or for business and commercial
and Wall-mount the Orbi Pro WiFi 6.