Lamp BNX Series User Manual page 11

anything on the cable of the cabinet.
• In the event of a malfunction, appropriate measures must be taken immediately (whether the
equipment is returned). The failed equipment cannot be allowed to continue to run.
• The components can only be connected using the cable specified for this display. In addition, be
careful to connect the signals only as described in the installation manual.
• The display should not be used near equipment that is not certified by 3C, CE, and UL/ETL.
• When reconnecting the components of the display, it must be wired in strict accordance with the
installation manual to prevent damage to the cables or other parts of the cabinet.
• In order to disassemble the module, you need to gently push the module from the back to avoid forced
unraveling.
• In addition to LAMP Tech's flight case or unit packaging box, other shipping tools should not be used
to transport the cabinet. In addition, even if transported using LAMP Tech's flight case or packaging
materials, there is no guarantee that the cabinet will not be damaged by excessive force. Packaging materials
can be ordered from LAMP Tech. All warranty claims for damage to the cabinet due to incorrect packaging
are null and void.
• The LED module mask can only be removed using the approved mask removal method described in
the installation manual.
• Clean the cabinet only in accordance with the procedures specified in the instruction manual.
Precautions
1. When opening the screen, please turn on the computer before turning on the LED display. When the
LED display is powered on, there will be a regional flashing, indicating that the screen is energized.
When the screen is off, first turn off the power of the LED screen, then turn off the control software,
and finally turn off the computer.
2. The newly installed LED display must be tested on the screen for the following operating
procedures:
A. When starting up for the first time, the screen brightness is set to 10% and keep this brightness
for 2 hours. Shut down for half an hour, then start up again and run according to this setting.
Execute the program for 4 cycles.
B. After completing Step 1 above, set the screen brightness to 30% and keep 30% of the screen
brightness for 8 hours. Shut down for 1 hour, then turn it on again and run according to this setting.
Execute this program for 2 cycles.
C. After completing Step 2 above, set the screen brightness to 50% and keep 50% of the screen
DISPLAY
第 7 页
Safety
A BETTER WORLD FOR ALL