Changing The Display; Usingthe Sleeptimer - Sony HT-DDWG700 Operating Instructions Manual

Changing the display
You can check the sound field, etc., by
changing the information on the display.
Be sure to use the buttons on the receiver for
this operation.
Press DISPLAY repeatedly.
Each time you press tile buttcm, tile disphty
changes cyclically as follows.
All inputs except the FM and AM
band
Index name of the input* -_ Selected input -_
Sound field currently applied
FM and AM band
Preset station name* -"'+ Frequency
Sound field currently applied
: Index name appears only when you h:,ve assigned
one to the input or preset station (page 42, 45).
Index name does not appear when only blank
spaces h:we been entered, or it is the same as the
input name.
Note
Character or marks may not be displayed for some
languages.
Usingthe SleepTimer
You can set the receiver to turn off
automatically at a specified time.
Press SLEEP repeatedly while the
power is on.
Each time you press the button, the display
changes cyclically as follows:
2-00-00 _ 1-30-00 --+ 1-00-00 --+ 0-30-00
-_ OFF
When sleep timer is activated, the display
dims.
Note
If you press any buttons on the remote or receiver
after the display dims. the display brightens up.
After a while, the display dims again if no button is
pressed.
Tip
To check the remaining time belk_re the receiver
turns off. press SLEEP. The remaining time appears
on the display. If you press SLEEP again, the sleep
timer will be canceled.
46us