Changing The Brightness Of The Front Panel Display - Sony HT-FS30 Operating Instructions Manual

Setting the sound from the
satellite tuner (INPUT MODE)
When multi-channel sound does not output, even
if you connect the system and the satellite tuner
via HDMI cable, connect the digital optical
cable.
• AUTO: Preferentially output the sound signal
from the HDMI SAT/CATV input
jack.
• OPT: Output the signal from the OPT SAT/
CATV IN jack.
Setting the Control for HDMI
function (CTRL HDMI)
You can change the settings of the Control for
HDMI function.
• ON: Set the Control for HDMI to "ON."
• OFF: Select this item when you want to
connect equipment not compatible with
"BRAVIA" Sync, or that do not have
HDMI jacks, etc.
Using the power saving
function on HDMI signal pass
through (PASS THRU)
Power consumption in standby mode is reduced
automatically when the TV is turned off.
• AUTO: When the TV is turned on while the
system is in standby mode, the system
outputs HDMI signals from the
system's HDMI output jack. We
recommend this setting if you use a
TV that is compatible with
"BRAVIA" Sync. This setting saves
power in standby mode compared with
the "ON" setting.
• ON: When the system is in standby mode, it
always passes HDMI signals through.
Note
• When "AUTO" is selected, it may take a little more
time for the picture and sound to be output to the TV
than when "ON" is selected.
38
GB
Setting the Audio Return
Channel (ARC) function
You can change the settings for the Audio Return
Channel (ARC) function.
• ON: Select this item when you connect the
system to a TV compatible with the
Audio Return Channel (ARC) function
via an HDMI cable.
• OFF: Select this item when you connect the
system to a TV via a digital optical cord.
Changing the brightness of
the front panel display
(DIMMER)
The brightness of the front panel display can be
set to one of 2 levels.
• ON: Dim.
• OFF: Bright.
Auto Standby function (AUTO
STBY)
You can reduce power consumption. The system
enters standby mode automatically when you do
not operate the system for about 30 minutes and
the system is not receiving an input signal.
• ON: Turns on the "AUTO STBY" function.
• OFF: Turns off the function.
Note
• When the system is turned off via the AUTO STBY
function, the system may not be turned on
automatically when you turn on the TV next time.
Checking the version of the
system (VERSION)
The current firmware version information
appears on the front panel display.