Advertisement
TO REMOVE/REPLACE
TRIMMER HEAD
DRIVE BELT
1. Remove screw at front of chassis
cover.
2. Lift cover up and away from trimmer.
3. Turn trimmer on its side with carbure-
tor and fuel cap up.
4. Remove belt from engine pulley on
crankshaft,
5. Remove belt from trimmer head pulley.
6. Remove idler assembly
from chassis
and remove belt and idler from
trimmer.
7. Remove belt from idler assembly
by
removing
bottom belt keeper and idler
pulleys.
8. Assemble
new belt, idler pulleys and
bottom belt keeper to idler bracket.
Tighten pulley bolts securely.
NOTE: Be sure belt is inside top belt
keeper on idler assembly.
9. Position belt and idler assembly
in
trimmer and assemble
idler to chassis.
Tighten securely.
10. Install belt around trimmer head pulley
and engine pulley,
11. Replace chassis
cover and tighten
screw securely.
Always use Craftsman
replacement
parts
to assure proper fit and long life.
Screw
Chassis
cover
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury.
If you
believe that the engine is running too fast
or too slow, take your unit to a Sears or
other qualified service center for repair
and/or adjustment.
CARBURETOR
Your carburetor
has a nonadjustable
fixed
main jet for mixture control.
If your engine
does not operate properly due to sus-
pected carburetor
problems,
take your
unit to a Sears or other qualified service
center for repair and/or adjustment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the
engine above the factory high speed
setting can be dangerous.
If you think the
engine-governed
high speed needs
adjusting, take your unit to a Sears or
other qualified
service center,
which has
proper equipment
and experience
to
make any necessary
adjustments.
Chassis_.
Belt
Top belt
""
keeper
Bolt
Engine
pulley
Nut
Spacer
V-idler
Idler
Idler
bracket
Flatidler
_Bottom
belt
keeper
Flat idler
. Trimmer
head pulley
Advertisement
