Sony SSC-C350 Operating Instructions Manual page 11

MONITOR OUT connector (in mode A)/VS IN connector (in mode B)
This is a BNC type coaxial connector to be used as follows depending on the
setting of the MODE switch [5].
Synchronizing signal
generator
When using the camera with a 12 V DC power supply directly conected, if the MODE
switch [5 ] setting is left at A, then a video monitor connected to this connector will
not get a correct video signal. In this case, set the MODE switch [5]to B, and
connect the monitor to the VIDEO OUT connector [9].
[11] DC 12V terminals
Connect these terminals to a 12 V DC power supply.
+: +12V
—: ground
When using a 12 V DC supply connected directly to these terminals, always set
the MODE switch [5 ]to B.
11