Display Section - Sony WRT-810A Operating Instructions Manual

Display section
AF indicator
The indicator appears when the input i
audio signal level is higher than needed
_ to obtain the reference deviation.
is being transmitted.
—
Wot er ani oH rong,
—————————-—— CH indicator
3 indicates the current wireless microhpne
channel selection in channel display or
channel set mode. When the unit is in
attenuation display/set mode, this
TVIATT
indicator -
indicator shows "~ ~".*
indicates the current TV channel selection
in channel display or channel set mode,
or the current input attenuation setting in
decibels in attenuation dispiay/set mode.
{
\BATT indicator
(a): The batteries are in good condition.
[al The residual battery power is below
the 50% level.
: The batteries are exhausted.
Replace them.
MOA men a ae seen h e :
Aan a a
e RA
|
+/— buttons —
see
a
ey
(When this indicator appears,
Use these buttons to increment or
the whole display starts flashing.)
decrement the channel selection in
channel set mode or the input attenuation
SET button
setting in attenuation display/set mode.
Use this button to enter channel set or
attenuation display/set mode.
+/-ISET buttons
+-— set
. rN
Use a ball-point pen or similar instrument
to press these buttons.
:
i
ah
sais
* The example shows TV channel! display on the WRT-810A(68) or
'
WRT-820A(68).