Starting And Stopping The Saw - Shindaiwa 488 Owner's Manual

STARTING AND STOPPING THE SAW
Ignition switch
Pull fo choke
WARNING!
The saw chain will rotate
when the saw is started! The saw
chain can cause serious injury!
Clear a safe work area before start-
ing this saw!
IMPORTANT!
The engine ignition is controlled by a
two-position "ON-OFF" switch located
near the throttle lever on the rear
handle. The ignition switch is typically
labelled "1" for ON and "O" for OFF.
Control Positions (cold engine):
1. Move the ignition switch up to the
"T (ON) position.
2, Choke the engine by pulling the
choke control to its fully extended
position (choke is closed)
. Set the throttle to "fast idle":
è First, depress the throttle lock
lever (#1).
+ Squeeze the throttle trigger (#2).
© Depress the throttle lock slide
switch (#3) toward the lock lever,
and release the throttle lever.
wo
Control Positions (warm engine):
1. Move the ignition switch to the "I"
(ON) position.
2. Choke contro! should be all the way
in (choke is open).
3. Set the throttle to "fast idle"
{as above).
IMPORTANT!
The throttle lever cannot be moved
without first depressing the lock lever.
13