Shindaiwa 488 Owner's Manual page 11

Chain orientation
BAR TIPS
Top of bar
Senta,
TEESE,
Hole in guide bar fits OX QO A
AAAA
i f A rcs
over chain tensioner pin Bottom of bar
5. Install the chain loop over the drive
sprocket, and then align the chain WARNING!
drive links within the guide bar
groove. Verify that the cutters are
properly oriented, and that the
chain tensioner pin is aligned as
shown. If chain installation is
difficult or if the chain appears too
tight, refer to "Adjusting the Saw
chain," (page 10)
Never operate this saw
without the clutch cover installed!
6. Install the clutch cover over the
bar studs. Using finger-pressure
only, install the bar nuts.