Sony LBT-G3000 Operating Instructions Manual page 9

'STEREO/MONO 2 Display 3
(came J ewes | care] wo] fom o e =
1 | ss | co [ames [omen |
TAPE cD TUNER VIDEO
| TAPE cD | TUNER VIDEO
TUNING/
PRESET
kHz
o
LO cr
Lu
i
DUAL MODE TUNING
Receiving
Broadcasts
You can listen to FM and AM stations.
1 Press the TUNER button.
2 Press the TUNING/PRESET button
to enter the tuning mode.
"PRESET" and the preset code
disappear.
3 Press the BAND button repeatedly
until the desired band appears.
Each time you press the BAND button,
the received band changes as follows:
poorest 2 2h men
4 Keep the DUAL MODE TUNING + or
- button pressed for over 1 second
so that "AUTO" appears.
The unit starts scanning frequencies and
stops when it tunes into a station.
Repeat this step until the desired station
is tuned in.
The "TUNED" indicator appears
When a station of sufficient signal strength
is tuned in.
The "STEREO" indicator appears
When an FM stereo program of sufficient
signal strength is tuned in.
When you press the TUNER
button
The CD player is automatically turned off
so that radio broadcast may not be
disturbed by noise.
For receiving FM stations in
stereo
If the MONO indicator is lit, press the
STEREO/ MONO button so that the
indicator goes out.
When an FM stereo program is
noisy or hard to receive
Press the STEREO/MONDO button to
change the mode over the MONO. This
eliminates the_stereo effect, but the noise
will be greatly reduced.
To return to the stereo mode, press the
STEREO/ MONO button again. The MONO
indicator goes off.
If you cannot tune in a desired
station
A station with a weak signal may be
skipped. In this case, tune in the station
manually.
* Press the DUAL MODE TUNING + or -
button again to stop scanning.
¢ Press the DUAL MODE TUNING + or -
button repeatedly and tune in the exact
frequency.
Note
The controls of the tuner become inactive
when you press any of the function buttons
other than the TUNER button.
9