Sony LBT-G3000 Operating Instructions Manual page 21

1-5
~ DISC SELECT
CHECK
CLEAR
CONTINUE
DISC SKIP
& OPEN/
CLOSE
Playing in a Desired
Order and Time
To erase the entire program
* Press the Mf button once during stop;
twice during play.
* Press the & OPEN/CLOSE button.
* Turn off the power.
+ Press the CONTINUE button.
If you press the PROGRAM
button during continuous or
shuffle play
The selection being played will be the first
one in the program.
To program a whole disc
+ Using the DISC SELECT 1-5 buttons
After steps 1 and 2:
1 Press one of the DISC SELECT 1-5
buttons to select the disc.
-2 Goon to step 5.
* Using the DISC SKIP button
After steps 1 and 2:
1 Press the DISC SKIP button to select
the disc, "AL" appears in the display.
2 Goon to step 5.
The whole disc is programmed as one step.
To check your program
Press the CHECK button. The first selection
in the program will be displayed.
Each time you press the CHECK button, the
next selection in the program will be
displayed. After the last selection, "End"
will be indicated and the display will soon
return to the initial status.
if the selection number is
displayed instead of the actual
time
— the total time is 100 minutes or more.
— you try to program over 24 selections.
Changing Your Program
You can make the following changes before
starting play.
To erase the last selection, press the
CLEAR button during stop mode.
Each time you press the CLEAR button
during stop mode, the last selection in the
program will be erased.
To delete a selection, press the CHECK
button repeatedly until the undesired
selection is displayed. Then press the
CLEAR button.
if you want to change the order, erase
the entire program by pressing the @
button in stop mode, and then repeat the
programming procedure from the
beginning.
21