Advertisement
_ |
TD-W20A/B/C/E/G/J
=
Removal
of Power Switch
(See Fig. 5)
1. Push the switch knob outward
to remove
it.
2. Push the switch ass'y in the direction of the arrow
to remove
it.
Note : When
reinstalling the switch ass''y :
1) Set the switch to its ON position.
2) Fix it as shown
in the right figure.
3) Set the knob to the switch.
Removal figure
reinstement figure
Fig. 7
Mechanical parts
@
Rec./PB head (Deck B) PB head (Deck A)
1) Remove
two screws 6) for the button assembly.
2) Remove a screw
:
3) Loosen a screw
for adjustment.
@
Erase head (Deck B) Dumy head (Deck A)
1) Remove a screw
2) Remove a screw
for adjustment.
@
Pinch roller arm assembly
1) Remove
a stopper
holding its assembly, and
pull it off from the shaft.
©@ Supply reel disc assembly
1) Pull out the E ring
67) and remove its disc from
the shaft.
@
Take-up ree! disc
1) Pull out the E ring
and remove it from the
shaft.
@
Motor
1) Remove three screws
2
and
fastening
the FM bracket. (When removing the FM bracket 42),
remove with the main belt
and the RF belt
44) .)
2) Remove three screws
45) fastening the motor.
3) Pull out the motor pulley from the motor shaft.
Fig. 9
Note: Be careful not to stain the main belt and RF belt.
(When
assembling
the motor
pulley, adjust the
pulley position as next figure.)
10.5mm
Fig. 10
MOTOR
Fig. 8
@
Flywheel assembly
Pull out the flywheel from the capstan metal.
(No. 4256) 7
Advertisement
