HP 41951A Operation Note page 17

GENERAL INFORMATION
Table 1-3. Accessories Available ( 2 of 2 )
HP 16093A Binding Post Fixture
A test fixture used when measuring miniature axial
and radial lead components. Two binding post
terminals at intervals of 7 mm on the terminal deck
ensure optimum contact of terminals and the test
sample leads.
The maximum DC bias that can be applied is
+40 V/+0.5 A.
HP 16093B Binding Post Fixture
A Test fixture for connecting common axial and
radial lead components. Three binding post ter-
minals are located on the terminal deck as shown
below.
©
i0. 5(mm)
The maximum DC bias that can be applied is
+40 У/+0.5 А.
НР 16094А Probe Fixture
Test Fixture for measurement of circuit impedances
and components mounted on circuit assemblies.
The probe adapter unit can be attached at the tip of
an extension line connected to the test port. The
probe connector fits APC-7 connector of a coaxial
test cable or a flexible air line. Probe needle inter-
val is variable from 1 mm to 15 mm. Electrical
length. compensation in the instrument must be
adjusted for probe cable length.
Usable frequency range: DC to 125 MHz.
Electrical length: 2.32 cm ( typical ).
Maximum applied DC bias voltage: +40 V.
1-11