Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Flebi Swan
Summary of Contents for Flebi Swan
- Page 1 User’s Manual...
- Page 2 Index Unpacking and assembly 9. Operation of the EN067 display 1. Contents of the box Folded & unfolded 2. Introduction of the handlebar assembly 3. Packed in original box 10. Unfolding the ebike 11. Folding the ebike Start-up 12. Opening and closing the frame 13.
-
Page 3: Contents Of The Box
Contents of the box The assembly of your Flebi Swan 24" is very easy and fast! Flebi Swan 24" is powered by a 36V / 250W motor and has a top speed of 25 km/h. -Take your Swan 24" out of the box... - Page 4 Unpacking and assembly Introduction of the handlebar assembly To install the handlebar and telescopic seatpost assembly that allows you to adjust the height, you must insert it into the stem before placing it in its natural position, following the guides that you will find.
- Page 5 Unpacking and assembly Packed in original box If you need to repack your bike in its original box to send it to Flebi service, we recommend that you follow the steps below: - Cover the parts with protection - Remove the seat post...
-
Page 6: Handlebar Adjustment
Start-up Handlebar adjustment You can adjust the height of the handlebars to suit your height. To do this, open the telescopic lock and place the seat post in the desired position, taking care not to exceed the safety mark. Then tighten the lock firmly so that it does not move. -
Page 7: Saddle Adjustment
Start-up Saddle adjustment You can also adjust the saddle height to suit your height. To adjust the hardness you must tighten the thread according to your taste. Make sure it is not too loose or the seat post will move. To change the angle of the saddle, you can use a number 13 spanner to set the saddle angle. -
Page 8: Brake Adjustment
Start-up Brake adjustment CAUTION: The brakes on all Flebi bikes are fully adjusted at the factory and no adjustment is necessary unless they become loose with use. If you need to adjust the brake calipers on your Flebi Swan 24", you have two types of adjustment: for brake force and alignment. -
Page 9: Tyre Inflation
Start-up Tyre inflation To check the amount of air in the tyres, remember that the Swan 24" carries between 2.5 and 4.8 bar of pressure, so it is advisable to use an inflator with a pressure gauge. The pressure will vary depending on the terrain you are riding on. -
Page 10: Recharging The Battery
Electrical operation Recharging the battery The battery of Swan 24" is inside the frame but can be removed from the frame for convenient charging. The charging point is located on the left side of the frame, under a rubber cover that must be removed to access the connector. - Page 11 Electrical operation Operation of the EN067 display The EN067 display is operated by pressing the power button on the bottom left of the display. Right next to it are the + and - buttons to increase or decrease the assistance level. When switched on, the display shows the km/h, the assistance levels and the remaining battery.
- Page 12 Folded & unfolded Unfolding the ebike The steps to unfold your Flebi Swan 24" are very simple: - Lift the bike and unfold the frame, tighten the central lock and place the lock. - Unfold the pedals - Lift the stem off the handlebars,...
-
Page 13: Folding The Ebike
Folded & unfolded Folding the ebike The steps to fold your Flebi Swan 24" are very simple: - Lower the handlebars - Release central locking mechanism of the frame - Fold the pedals - Open the frame and bring it to the... -
Page 14: Opening And Closing The Frame
Folded & unfolded Opening and closing the frame To open or close the frame, you only have to remove the lock in the central part in case of opening and put it on in case of closing. Video: https://youtu.be/i_O8EZp8d0M... - Page 15 Folded & unfolded Folding and unfolding the pedals Install the pedals of your Flebi Swan 24" very easily with this tutorial. To fold or unfold each pedal you must press the knob outwards and, at the same time, fold the pedal inwards (folded) or outwards (unfolded) until you feel the lock.
- Page 16 Folded & unfolded Handlebar folding mechanism First of all, make sure that the cables are not tangled or too tight due to the set handlebar height. You can adjust the height and inclination of the handlebars. The bike has an indicator on the inside of the handlebars to show the maximum height.