Pentax ZOOM 60-X Operating Manual page 29

Correcting the data
1. Press the SELECT button ©until you reach the
flickering digit(s) which you wish to change.
2. Press the ADJUST button ©to change digits within the
specified category chosen using the SELECT button
© Digits increase by one each time you press the
ADJUST button © if you hold down the button, the
digit will advance continuously after two or three
seconds.
3. After the adjustment is made, press the SELECT
button © The bar mark { — ) appears on the date
indicator, indicating that data imprinting choices are
possible.
Notes:
• When the flickering data on the date indicator is being
corrected, it cannot be imprinted even if the shutter Is
released.
• Date and time are indicated as follows:
Year= 87-19(1987 - 2019)
Month = 1 -12
Day = 1 - 31
Hour = 0-23
Minute = 00-59
• The flickeringallows precise fine-tuning of the internal
clock to the beginning of a specified minute. To make
this ajustment, press the SELECT button 0 until will
flicker. Then, press the ADJUST button ©in sync with
a time signal.
Date imprinting
The (Year-Month-Day) or (Day-Hour-Minute) data is
recorded on the lower right of a picture. The data on the
date indicator is imprinted on each frame you expose.
Notes:
• If the corner of the picture has a white or yellow object,
the imprinted data will be difficult to see. When
composing, try to avoid a brightly colored subject in that
corner.
• "Year-Month-Day" and "Day-Hour-Minute" cannot both
be printed at the same time.
• As you release the shutter, the bar mark ( — ) on the
date indicator flickers for a few seconds, indicating the
data has been imprinted.
Power source of the data-imprinting section
The data imprinting section is powered by the batteries in
the camera's main unit. When the batteries are replaced,
the data and time may change. So, after replacing the
batteries, make sure to confirm the date and time before
use.