Zanussi FJ 1200 Instruction Booklet page 19

Hide thumbs Also See for FJ 1200:
Table of Contents

Advertisement

Cleaning the filter
The water drain filter
A clean filter is important for the correct functioning of
the machine, and should therefore be cleaned after
every wash.
Open the filter door and
place a container under-
neath to catch any spill-
age. If the filter is blocked
and the machine is un-
able to drain you will need
e
to drain the water manu-
ally from the machine at
this stage. To do this,
PoouL
unhook
the drain hose
from the standpipe or sink and hold the end of the hose
over a bowl on the floor. The water should drain by
gravity into the bowl. When the bow! is full, hook the
hose back up and empty the bowl. Repeat the proce-
dure until water stops flowing out.
Unscrew and remove the filter.
Clean carefully under a
fast running tap.
Warning
When the appliance is in use and depending on the
programme selected there can be hot water in the filter.
Never remove the filter during a wash cycle, always wait
until the appliance has finished the cycle, and is empty.
When
replacing the filter, ensure
it is securely
retightened so as to stop leaks and young children being
able to remove it.
The water inlet filters
lf your water is very hard or contains traces of lime
deposit, the water inlet filters may become clogged.
It is therefore a good idea to clean them from time to
time.
Turn off the water taps. Unscrew the water inlet hoses.
Remove and clean the fil-
ters using a hard bristle
brush. Replace the filters
and tighten up the inlet
hoses.

Advertisement

Table of Contents
loading

Table of Contents