IHP DEL SOL Installation Instructions

INSTALLATION INSTRUCTIONS FOR INSTALLING LOUVER KITS. FOR USE WITH VILLA VISTA™, VILLA VISTA CD,
WRT4826WH, WCC4826W AND BIS
KIT CONTENTS
1 ea. Top Grill Assembly
1 ea. Bottom Grill Assembly
2 ea. Type F Star Screws 10-32 x 1/2"
(Villa Vista and WRT4826WH Louver Sets only)
1 ea. Instruction Sheet
LOUVER KITS
Cat. No. Model
DEL SOL DEL SOL
DIAMANTE DIAMANTE
STRADA STRADA
F3366 VVCD-GRILL-HOLLISTER
F3367 VVCD-GRILL-SLEEK
F3368 VVCD-GRILL-MADERA
Villa Vista
Del Sol
Diamante
Strada
GENERAL INFORMATION
These decorative louvers are offered in various attractive styles and fit
on the face of the appliance.
If you encounter any problems, need clarification of these instructions or are
not qualified to properly install this kit, contact your local distributor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
SHUT DOWN THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
INSTALLATION
Step 1. Installing the Top Frame and Louver Assembly; Figure 1A, Villa
Vista. Insert the assembly into the top opening, holding it straight and as
close as possible to the inner top frame. Then lower the assembly, attaching
it to the support screws inside the frame. Figure 1B, Villa Vista CD. Insert
the assembly into the top opening directly, holding it straight and as close
as possible to the inner top frame.
IHP reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor
for fireplace code information.
Printed in U.S.A. © 2001 Innovative Hearth Products
P/N F119 Rev. E 08/2017
PANORAMA WOOD-BURNING FIREPLACES
®
Where Used
Villa Vista™ & WRT4826WH
Villa Vista & WRT4826WH
Villa Vista & WRT4826WH
Villa Vista CD & WCC4826W
Villa Vista CD & WCC4826W
Villa Vista CD & WCC4826W
Villa Vista CD
Hollister
Madera
Sleek
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
P/N F119
Rev. E, 08/2017
Step 2. Installing the Bottom Frame and Louver Assembly Figure #1A, Villa
Vista. Insert the assembly into the bottom of the opening directly. Make sure
that the air control lever (located on the left side) is in the correct position
between the frame and the louvre assembly. When the assembly is in posi-
tion, open the louvre and secure the frame to the unit using the screws (2)
included in the package. Figure 1B, Villa Vista CD. Insert the assembly into
the bottom of the opening directly, holding it straight and as close as possible
to the inner top frame. Make sure that the air control lever (located on the left
side) is in the correct position between the frame and the louvre assembly.
Figure 1A
Air control damper
Figure 1B
Air control damper
Innovative Hearth Products
1508
HEARTH PRODUCTS
KITS AND ACCESSORIES
LOUVER KITS
Villa Vista & WRT4826WH
Top Frame
(installed at the factory)
Top Louver
Support Screws
Top Louver
Bottom Frame and
Louver (pre-assembled)
2 srcews
Villa Vista CD & WCC4826W
Top Frame and Louver
(pre-assembled)
Bottom Frame and Louver
(pre-assembled)
Elm Hill Pike, Suite 108 • Nashville, TN 37210
1