Toshiba MMD-UP0721HFP Series Service Manual page 52

To find an indoor unit's position from its address
When checking unit numbers controlled as a group
<RBC-AMT32E>
(Execute it while the units are stopped.)
The indoor unit numbers in a group are indicated one after another. The fan and louvers of the indicated units
are activated.
1
Push and hold the
ALL ALL
ALL ALL ALL
• appears on UNIT No. on the LCD display.
• The fans and louvers of all the indoor units in the group are activated.
2
UNIT LOUVER
Push the button (left side of the button). Each time you push the button, the indoor
unit numbers are indicated one after another.
• The first-indicated unit number is the address of the header unit.
• Only the fan and louvers of the indicated indoor unit are activated.
3
Push the button to finish the procedure.
All the indoor units in the group stop.
<RBC-ASCU11-C>
1
1
Push and hold the [menu +
e.g.)A unit number 1-1 is indicated on the LCD. The indicated number shows the system
address and indoor unit address of the unit.
2
When 2 or more indoor units are connected to the remote controller (group-controlled
units), a number of other connected units appears each time you push the [
buttons.
3
Push the [ON/OFF] button, return to the normal mode.
TEMP.
TIMER SET
3
TIME
Stop
FILTER
RESET TEST SET CL
1
and buttons at the same time for more than 4 seconds.
2
3
] buttons at same time for more than 10 seconds.
ON / OFF
FAN MODE
1
SAVE VENT
SWING/FIX UNIT LOUVER
2
- 52 -
or ]