Film Holders 645 And Attaching/Detaching.13 - Pentax 645 Operating Manual

FILM HOLDERS 646 AND ATTACHING/DETACHiNG
The following film holders are available, depending
upon your photographic requirements; each
provided with its own exclusive case for carrying
convenience and protective purposes.
• 120 film holder: For 120 film (15 frames per roll)
• 220 film holder: For 220 film (30 frames per roll)
• 70mm film holder: For 70mm film (approx. 90
frames per roll)
• Attaching / detaching of 120/220 film holders
When inserting the film holder into the camera body,
be careful not to make its upside down to avoid any
serious damage.
1. Align the red dots on the film holder and film
holder key as shown, then insert the film holder
into the camera chamber. Make sure that two tabs,
lock in place with a film click when the film holder
is inserted.
2. Lock it by rotating the film holder key 90* to
the right while simultaneously depressing the
key. After locking, the film holder key should be
folded into its original position.
3. Raise the film holder key and rotate until the red
dot markings are aligned. Continue to rotate the
key counterclockwise up to the end of the red
line; the locking mechanism will release with an
audible click, permitting the film holder to be
removed from the camera body.
Refer to the 70mm film holder operating manual
for its use.
13