BLADE
REPLACEMENT
(Continued)
WARNING:
Blades are sharp. When manually
sliding blade assembly, do not place your hand
or fingers between blades or in any position
where they could get pinchedor cut,
•
Replace blade screws. Tighten screws securely.
•
Replace blade cover screw. See Figure 16.
Note: Do net tighten until blade cover has been
replaced.
BLADE COVER
REARTAB
BLADE
BLADE
SCREWS
Fig. 16
•
Replace blade cover. Place rear tab inside hous-
ing, align front tabs with slots in housing,then slide
blade cover back intoits correct position.Sea
Figure 17.
FRONT TABS
BLADE COVER
SUDEBLADE COVER
BACK INTOPosmoN
• Tighten blade cover screw securely.
Fig. 17
_1= WARNING:
Make sure blade cover is replaced
before connectingyour hedge trimmerto power
supply. Failureto do so will expose internalparts
whichcould cause an accident or electrical
shock resuttingin serious injury,
Note: If binding occursafter replacing blade
assembly, repeat the stepsabove for reassembly.
11