Download Print this page

Craftsman F1294 Operator's Manual page 2

Craftsman tool storage user manual

Advertisement

Available languages

Available languages

Call 1-800-366-7278
for Service Parts
Refer to Service
Parts Drawing
for full listing of Service
Parts
HARDWARE:
_Li_'
_;_,,.2_
_
14--10 x 3/4 PHILLIPS
SCREW
!Y_%, _,_._.;,:_
_C_7/_ _;j_<4_
14-10 x 5/8 HEX
SCREW
• Attach each caster using (4) 14-10x5/8
hex screws per caster.
• Wrench tighten all screws.
• Return the cart to its upright position.
SIDE HANDLE
ATTACHMENT:
NOTE: Holes in the handle are tapped
requiring no nuts for installation.
• Attach the side handle using (4) 14-10 x
3/4 phillips screws. Do not over tighten
screws.
\
CASTER
INSTALLATION:
NOTE: Use adequate manpower for this
operation.
• Lay the cart down on its back. Use
packaging material to protect the paint
finish.
• Mount both swivel casters on the same
side of the cart.
REMOVING
AND INSTALLING
DRAWERS:
• Empty the drawer.
• Fully extend the drawer.
• Depress the release tab on both sides,
(this allows the slides to ride over the
stops). Pull out to remove
• To reinstall, carefully align the slides and
slowly push the drawer into the unit until
the drawer stops.
Release
Left
Right
• To remove the slide from the unit, first
remove the drawer (follow the procedure
above). Lift and hold the spring retainer,
and push the slide upward. The slide
may now be removed.
/
/
Spring
Retainer
To reinstall the slide, place the slide in
the appropriate position in the unit. Pull it
toward the front of the unit until the spring
retainer snaps into position and secures
the slide.
• For casters, use high quality bearing
grease, (yearly).
• Lubricate the slides, (twice yearly).
• Lubricate lock with graphite, (yearly).
• Periodically the drawer fronts, drawer
trim, and other surfaces should be
cleaned with a mild detergent and water.
• Auto wax wilt preserve the storage unit's
luster finish. Apply the wax as to a car.
The wax wilt also help protect the unit
against scratches.
• Grease and oil can be removed with
most standard cleaning fluids. For
safety, use a nonflammable
cleaning
fluid.
• If drawer liners are supplied, it is
recommended they are used to protect
the finish inside the drawers and to
make the drawers easier to clean. The
drawer liners may be cleaned with soap
and water.
3
4

Advertisement

loading

This manual is also suitable for:

Ball bearing series
Save PDF