Intex PureSpa 28454AG Owner's Manual page 10

Press the button to turn on the control unit panel
4.
buttons fi rst. Press the
spa tub wall for 8 to 10 minutes until it is fi rm to the
touch but not hard (see drawing 5).
IMPORTANT: Do not over infl ate or use high pressure
air compressor to infl ate.
Press the button again to turn it off.
5.
Replace the air valve cap back.
6.
NOTE: The cap is designed to be screwed on and
off. Never exert force as this could cause the complete
internal infl ation system of the valve to come loose.
See "Spa Tub Air Valve Fastening" for valve maintenance.
Infl ate the Spa Cover Air Bladder
Open the infl ation valve and insert the infl ation
1.
hose (7) into the valve; press
until it is fi rm to the touch but not hard (see
drawing 6).
Disconnect the infl ation hose (7) from the air
2.
blower infl ation outlet and the valve.
Replace the control base infl ation cap (9) back;
3.
close and recess the infl ation valve.
NOTE: If there is a need to add some air to the spa tub wall or spa cover air bladder after they have been
setup, refer to above "Infl ate the Spa Tub Wall" and "Infl ate the Spa Cover Air Bladder" sections. The cover
air bladder is preinstalled inside the spa cover. If it needs to be reinstalled, place the uninfl ated air bladder
inside the spa cover lip before infl ating the bladder.
S AVE THESE INSTRUCTIONS
(299AG) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 06/26/2017
SET UP (continued)
button to infl ate the
to infl ate
7
299
English
AG
5
6
Page 10