Advertisement
KNX/EIB
Push button sensor 3 Plus F100
5.2 Commissioning
Loading the physical address and application software
(15) Programming LED
(16) Programming button
The programming button and LED are located under the rocker covers (picture 5).
The rocker cover (12) and rocker support (10) over the programming button are dismantled.
i If the device does not receive any application software, or the wrong application software,
then the operation LED (4) flashes.
o
Press the programming button (16).
The programming LED (15) lights up.
o
Assign physical address.
The programming LED goes out.
o
Load the application software into the device.
o
Mount the rocker support (10), inscription panel (11) and rocker cover (12).
6 Appendix
6.1 Technical data
KNX medium
Commissioning mode
Rated voltage
Power consumption
Connection mode
Safety class
Ambient temperature
Storage/transport temperature
6.2 Accessories
Bus coupler 3
Bus coupler 3 external sensor
Remote sensor
Second support ring
Inscription sheet (21x)
Inscription sheet (48x)
32575702
410946 I00
picture 5
14.07.2010
DC 21 V ... 32 V SELV (Via bus coupler 3)
max. 420 mW (Via bus coupler 3)
10 pole male connector strip
TP 1
S mode
III
-5 ... +45 °C
-20 ... +70 °C
Order-No. 2008 00
Order-No. 2009 00
Order-No. 1493 00
Order-No. 1127 00
Order-No. 2872 ..
Order-No. 2874 ..
6/7
Advertisement
