Table of Contents
Advertisement
• In case of that the depth of the washing
machine is 550 mm or more and 599 mm or
less
• In case of that the depth of the washing
machine is 600 mm or more and 650 mm or
less
4
Fasten the 2 screws that were removed earlier
from the appliance to the stacking kit.
5
Use the 4 screws in the accessory box (16 mm)
to assemble the washing machine rear cover
and stacking kit.
6
The procedure for the opposite side will be the
same.
Installing the Optional Drain
Hose
Normally, condensed water is pumped up to the
water container where water is collected until
manually emptied. Water can also be drained out
directly to a mains drain, especially when the
appliance is stacked on top of a washing machine.
With the connecting elbow or T piece of the mains
drain hose, simply change the water path and re-
route to the drainage facility as below:
1
Separate the anti-backflow lid
container hose
from the connecting elbow
b
or T piece.
2
Attach the anti-backflow lid
the connecting elbow or T piece and then
connect the optional drain hose
opposite side of the connecting elbow or T
piece.
CAUTION
• If the optional drain hose is installed in a way
that leaves it bent or pinched, drainage may not
function properly.
INSTALLATION
and the water
a
b
a
to the head of
a
to the
c
a
c
15
Advertisement
Table of Contents
