Pioneer SX-2600 Operating Instructions Manual page 9

DIRECT ACCESS TUNING
NOTE:
Example 1: To receive FM 106.00 MHz
DIRECT ACCESS tuning indicator lights up
Paty
Press the switch *1.
ees i ron
| Press the switch *0.
-,
| Press the switch *6,
3 g co
co
a ca
2
-
Press the switch *O.
Once the station frequency has been input, the receiver tunes in that
frequency. If the input frequency fails below the lower or higher limit
of the receiver's receivable frequency range (FM: 87.5 MHz — 108
MHz; AM: 530 kHz — 1,700 kHz {10 kHz step), 531 kHz ~ 1,602
kHz (9 KHz step}) "LOWER" or "UPPER" is displayed, indicating that
the frequency which has been input cannot be tuned in
5. Adjust the sound volume and tone as desired.
To cancel frequency input
Direct access is canceled when the DIRECT ACCESS tuning switch is
pressed again
Under the following conditions direct access is canceled and the unit
returns to the condition in effect before direct access was selected: (7)
ff there is no key input for about five seconds after the DIRECT ACCESS
tuning switch was pressed. '2)1f more than about eight seconds elapse
between number input.
Notes regarding direct access tuning (100 kHz step only)
There is no need to input the last digit "'O'' of the desired station
frequency.
8
<ARBI214>