Pioneer SX-2600 Operating Instructions Manual page 10

FREQUENCY PRESETTING
1 2 4
NOTE:
8e sure to turn the TAPE 2 MONITOR switch OFF when listening to
AM or FIM broadcasts.
2. Set the BAND selector to either FM or AM.
3. Tune in the desired station.
* See the section "DIRECT ACCESS TUNING" for information on
reception using the Direct Access Tuning mode.
* See the section "AUTO TUNING" for information on reception
using the Auto Tuning mode.
* See the section "MANUAL TUNING" for information on reception
using the Manual Tuning mode.
In addition to station frequencies, the FM MODE (AUTO/MONO}
can also be preset.
4. Press the MEMORY switch.
5. Press the STATION CALL switch into which you wish
to preset the station.
* Press the STATION CALL switch while the MEMORY
indicator
is flashing (about 5 seconds).
« Use the STATION CALL switches (*1
— "9, *O} to select a preset
channel. One press seiects the 1 — 10 range, two presses 11 -
20, and three presses 21 30.
[Example] If you press key {*3] 8
Once — STATION 3
Twice — STATION 13
Three times — STATION 23
Press a STATION CALL switch within two seconds.
NOTE:
10
<ARB1214>
NOTE:
Last station memory
The last received AM and FM stations remain stored despite FUNCTION
and/or POWER
switching. To recall, use BAND selector switches.
STATION CALL NO | NAME
1-10 | POP
11 ~ 20 | ROCK
21-30 0 | OTHER