Table of Contents
Advertisement
Using the Preset Buttons
Your receiver allows you to store 16 station
settings and quickly access them, using the
8 Preset buttons along with the Shift A-B
button. The Preset stations are designated
by the letter A or B, followed by a number
from 1 to 8. Any designation may be used
for any AM or FM station, in whatever
combination you choose.
To enter a station in memory:
1. Tune to the desired station.
2.
Be sure Seek-Stereo setting is the one
desired"*.
3.
Press the Shift A-B button to display the
desired letter.
4.
Press the Memory button.
("Preset" will
flash for about 8 seconds.)
5. With "Preset" flashing, press the desired
numbered Preset button.
*NOTE:
When a station is set in memory,
the Seek-Siereo setting is also entered.
Subsequently, each time a station is
recalled using a Preset button, the tuner
automatically switches to the original Seek-
Stereo setting for that station.
|
|
Shift A-B
5
To change a preset station:
Simply enter the new station. The old
station is automatically erased.
To access a preset station:
Press the Shift A-B button to display the
correct letter. Then press the desired
numbered Preset button.
NOTE:
Preset stations are stored
indefinitely while the unit is connected to a
live AC source, and for approximately
1
week when the unit is unplugged.
Making a Recording
When you select Video, Tuner, CD or Phono
as your sound source, recordings may be
made on tape deck 1 or 2, or both
simultaneously. When making recordings
on tape decks 1 and 2 simultaneously, you
may listen directly to the source, or you
may monitor tape deck 2. DO NOT monitor
tape deck 1 during this procedure.
If you wish to copy a tape, place it in deck
1, and press the "Tape 1" button on your
receiver. You may then record the tape
using tape deck 2.
Tape 1/Copy
Tape 2
ae
NOTE:
To turn off the Tape 1 or Tape 2
selection, press either Video, Tuner, CD or
Phono.
12
Advertisement
Table of Contents
