Kenwood 103AR Instruction Manual page 6

103AR (En)
Connection of sneakers
Speaker system A
I
Speaker protection circuitry
I i;
\"e
s::eake^ cords are sro't-c:'c_ited, ■'i-e speaker protection.
I j'"', s activated a''d sojnd is rriutec I' tois occurs.
I SA tC- "A:. power Key to Of-*-, reoiove toe scort-circuit from
'''c- s:>:-a-c' cc'GS, ana svyitc" f'.r.
POWER
';ev to ON agam
R L
Speaker system B
• Never short-circuit the + and - speaker cords
• If the lett and right speakers are connected inversely or if the
speaker co'ds are connected with reversed polarity, the sound
becomes unnatural with ambiguous acoustic image positioning.
Be Sure to connect the speakers and speaker cords correctly
4
i
Setting the speaker IMPEDANCE SELECTOR
When Lisirig the speaker A or speaker B separately
Speaker impedance
Selector position
4 IJ 6
ii. \
'
n<
S ii
16
-€n
When using the speaker A and B simultaneously
Speaker impedance Selector position
S LI.
16
il
►
CAUTION
ITO PREVENT FIRE OR DAMAGE REQUIRING
SERVICE, SET THE IMPEDANCE SELECTOR
SWITCH AS DESCRIBED BELOW.
Accordmn to the impedar'ce of tne soeakers used, set the speaker
IMPEDANCE SELECTOR
on the rear panel as shown in the table.
• When the
IMPEDANCE SELECTOR
switch is set to '
AorB:
LESS THAN 812, AandB: 80 OR MORE",
n 'S possible to use
tne A and B speakers at the same time.
Therefore, when using the speakers A and B simultaneously, be
Sure
to set the
IMPEDANCE SELECTOR
switch to tne
"AorB:
LESS THAN 812, AandB; 812 OR MORE"
position
• During speaker system connection and operation of the speaker
IMPEDANCE SELECTOR,
set the
REMOTE POWER
key to OFF