Table of Contents
Advertisement
Refer
to
P.29
for
an
explanation
of |
LOADING BATTERIES
REMOTE CONTROL RANGE
4. Open the battery compartment cover on the rear of the remote
When operating the remote control unit, point the front of the unit at
controt unit. The cover should open easily if you slide it in the
the front panei of the receiver, The remote control unit may be used
direction of the arrow while pressing on it with your thumb.
within a range of about 7 meters (23 feet) from the remote sensor,
2, Take out the four supplied alkaline batteries (LRO3/AM-4), and
within angles of up to about 30 degrees.
insert them into the battery compartment in accordance with the
indications in the compartment.
3. Close the cover of the battery compartment.
Cover
7m (23 feet)
Battery Replacement
When the batteries have run out, the transmit indicator will not illuminate
even when a key is pressed. Be sure to replace the batteries as scon
Reset button
as possible. As the programmed functions will be retained in memory
only as long as batteries are inserted, remove the old batteries only if
Incorrect use of batteries may lead to leakage or rupture.
they can be replaced by new ones immediately.
Always be sure to follow these guidelines:
Also, be sure to always use the specified batteries.
(size "AAA
A
{LRO3/AM-4) alkaline batteries}
Always insert batteries into the battery compartment correctly matching
NOTE:
the positive + and negative
—
polarities, as indicated inside the
When no batteries are inserted, the programmed memory contents will
compartment.
be erased after 30 to 60 minutes.
8.
Never mix new and used batteries.
c.
Batteries of the same size may have different voltages, depending on
their type. Do not mix different type of batteries.
35
<ARBII74>
Advertisement
Table of Contents
