Pioneer KEH-P5000 Owner's Manual page 11

Fader
When you press the (+) side of button [1],
the front speaker volume increases gradual-
ly while the rear speaker volume decreases.
When you press the (—) side the button, the
rear speaker volume increases gradually
while the front speaker volume decreases.
(Display shows "FAD. F9" ~ "FAD. R9".)
* Please set "FAD. 0" when using 2 speaker
system.
Balance
Pressing the (4) side of button [1] shifts the
balance to the left speaker, while the (>)
side shifts it to the right speaker.
(Display shows "BAL. L9" ~ "BAL. R9".)
Tone Adjustment
Press button [13] to select tone adjustment
mode. ("BAS" appears.) Select the tone
you wish to adjust using the (<4) or (P) side
of button [1]. Pressing the (P) side boosts
the TRE: pressing the (<4) side boosts the
BAS. :
Bass Adjustment
Select the Bass mode.
Pressing the (+) side of button [1] increases
bass, while the (-) side decreases bass.
(Display shows "BAS. -6" ~ "BAS. 6".)
Treble Adjustment
Select Treble adjustment mode.
Pressing the (+) side of button [1] increases
treble, while the (-) side decreases treble.
(Display shows "TRE. -6" ~ "TRE. 6".)
Loudness Select
This "loudness" function enhances both
the high and low ranges of sound to give
even more power to output even at low
volume.
Press button [13] to select loudness select
mode. (The "LOUD" indicator appears on
the display.)
Pressing the (P) side of button [1] turns the
loudness function on; pressing the (4) side
turns it off.
Using Source Level Adjuster
You may wish to adjust volume when you
have changed the source to radio, tape, CD
or AUX or when you have changed the ra-
dio band from FM to MW/LW. You can do
so on the basis of the volume of FM as
follows:
1.Use the button [2] to change the source.
(In case of radio, change the band to
MW/LW.)
2.Hold down the button [13] for about 2
seconds, and the display will show you
the volume of the source.
(Display shows "V. -4" ~ "V. +4",)
3.Pressing the (+) side of button [1] raises
the volume and pressing the (-) side low-
ers it. About 8 seconds after the comple-
tion of the adjustment, the display returns
to whether it was showing before the ad-
justment.
No adjustment can be made when an FM
station is tuned in.
11