Starting The Treadmill From Desktop Console - EGOFIT ComfortDeck M2 Owner's Manual

Starting the Treadmill from Desktop Console

1. Turn the power switch on. It is located on the front right corner of the
treadmill.
2. Press the Start button to start the treadmill belt. The console will start
counting up from 0:00.
3. Press the speed buttons to adjust speed.
The steps are counted normally from 1 to 9,999 steps. After 9,999 steps,
the display format changes to accommodate more than four digits. Take
the number shown in the display and add a zero to the right for the
correct number of steps.
Below are examples of what the display will read and what those numbers
1001=10,010 steps 1005=10,050 steps
NOTE:
mean:
1100=11,000 steps
Belt Lubrication
Use only 100% silicone and avoid using aerosol silicone sprays which
include additives and petroleum distillates. One ounce of silicone should be
used for each application. Egofit offers 100% silicone lubricant that can be
ordered at www.egofitwalker.com.
The walking belt comes pre-lubricated from the factory. The M2 and M2T
should be lubricated every 3 months (regardless of use) or every 50 hours
of use.
To lubricate, unplug your treadmill. Slide your hand
under the belt and lift the belt away from the deck.
Apply about a dozen sprays toward the center of
the belt from each side. Rotate the belt 1/3 and
repeat this application. Rotate another 1/3 and
repeat once more. Plug the treadmill in and walk
for a few minutes to disperse lube evenly.
Belt Tensioning
If the belt begins to slip and needs to be tensioned, tension bolts are
accessible from the back of the treadmill. Before tensioning the belt, start
the treadmill and set the speed to 3 mph (5 kmh).
A. Using a 6 mm Allen wrench, included in your hardware bag, turn the
right and left tension bolts 1/2 turn clockwise.
B. Test to see if the slipping is eliminated. If the belt slips repeat step A
and test again
Note: Over tensioning the belt can cause unnecessary friction and
wear and tear on the belt, motor and electronics.
Note: Adjusting one side more than the other will cause the belt to
drift to the side of the treadmill and will require belt alignment. Check
to be sure the running belt is still aligned. If belt alignment is off as
shown below, refer to Belt Alignment section.
18
17