Brake Pedal; Abs (For Abs Models) - Yamaha Fazer 8 2014 Owner's Manual

Brake pedal

1
1. Brake pedal
The brake pedal is located on the right
side of the motorcycle. To apply the
rear brake, press down on the brake
pedal.
INSTRUMENT AND CONTROL FUNCTIONS
EAU12944

ABS (for ABS models)

The Yamaha ABS (Anti-lock Brake
System) features a dual electronic con-
trol system, which acts on the front and
rear brakes independently.
Operate the brakes with ABS as you
would conventional brakes. If the ABS
is activated, a pulsating sensation may
be felt at the brake lever or brake ped-
al. In this situation, continue to apply
the brakes and let the ABS work; do
not "pump" the brakes as this will re-
duce braking effectiveness.
WARNING
Always keep a sufficient distance
from the vehicle ahead to match the
riding speed even with ABS.
 The ABS performs best with
long braking distances.
 On certain surfaces, such as
rough or gravel roads, the brak-
ing distance may be longer with
the ABS than without.
The ABS is monitored by an ECU,
which will revert the system to conven-
tional braking if a malfunction occurs.
3-14
EAU51802
TIP
 The ABS performs a self-diagno-
sis test each time the vehicle first
starts off after the key is turned to
"ON" and the vehicle has traveled
at a speed of 10 km/h (6 mi/h) or
higher. During this test, a "click-
ing" noise can be heard from un-
der the seat, and if the brake lever
or brake pedal is even slightly ap-
plied, a vibration can be felt at the
lever and pedal, but these do not
indicate a malfunction.
 This ABS has a test mode which
EWA16051
allows the owner to experience
the pulsation at the brake lever or
brake pedal when the ABS is op-
erating. However, special tools are
required, so please consult your
Yamaha dealer.
NOTICE
Keep any type of magnets (including
magnetic pick-up tools, magnetic
screwdrivers, etc.) away from the
front and rear wheel hubs, otherwise
the magnetic rotors equipped in the
3
ECA16121