ELEQ RM17 Installation Manual

Technical Specifications

Technical Specifications
Technical Specifications
Safety and environmental conditions
Safety and environmental conditions
Safety and environmental conditions
CE marking LV directive 2014/35/EU
CE marking LV directive 2014/35/EU
CE marking LV directive 2014/35/EU
RoHS directive 2015/863/EU
RoHS directive 2015/863/EU
RoHS directive 2015/863/EU
Standard EN-IEC 61010-1:2010
Standard EN-IEC 61010-1:2010
Standard EN-IEC 61010-1:2010
WEEE directive 2012/19/EU
WEEE directive 2012/19/EU
WEEE directive 2012/19/EU
This product is designed to be safe under the following
This product is designed to be safe under the following This product is designed to be safe under the following
conditions:
conditions:
conditions:
Location Indoor use
Location Indoor use
Location Indoor use
Altitude Up to 2000m
Altitude Up to 2000m
Altitude Up to 2000m
Ambient temperature -10°C .. +55°C
Ambient temperature Ambient temperature -10°C .. +55°C -10°C .. +55°C
Storage temperature -20°C .. +70°C
Storage temperature -20°C .. +70°C
Storage temperature -20°C .. +70°C
Relative humidity 5% .. 85%, non condensing
Relative humidity 5% .. 85%, non condensing
Relative humidity 5% .. 85%, non condensing
Pollution degree 2
Pollution degree 2
Pollution degree 2
Degree of protection IP20
Degree of protection Degree of protection IP20 IP20
The RM17 is only suitable for insulated primary conductors.
The RM17 is only suitable for insulated primary conductors.
The RM17 is only suitable for insulated primary conductors.
Specifications Specifications
Specifications
Standard Standard IEC 61869-2:2012* IEC 61869-2:2012*
Standard IEC 61869-2:2012*
Rated short-time thermal current Rated short-time thermal current
Rated short-time thermal current
(Ith): (Ith): 60 x In /0,1 s 60 x In /0,1 s
(Ith): 60 x In /0,1 s
Rated dynamic current (Idyn) Rated dynamic current (Idyn) 2,5 x Ith 2,5 x Ith
Rated dynamic current (Idyn) 2,5 x Ith
Continuous thermal current (Icth) 100% (32 A)
Continuous thermal current (Icth) Continuous thermal current (Icth) 100% (32 A) 100% (32 A)
Rated insulation level 0,72/3/-kV
Rated insulation level Rated insulation level 0,72/3/-kV 0,72/3/-kV
Rated frequency 50/60 Hz
Rated frequency Rated frequency 50/60 Hz 50/60 Hz
Class of insulation E (120°C)
Class of insulation E (120°C)
Class of insulation E (120°C)
Material PA 6.6, UL94: V2
Material Material PA 6.6, UL94: V2 PA 6.6, UL94: V2
Secondary terminal Female connector
Secondary terminal Female connector
Secondary terminal Female connector
(clamping)
(clamping)
(clamping)
suitable for conductor
suitable for conductor
suitable for conductor
size: 0,2 .. 1,5 mm²
size: 0,2 .. 1,5 mm²
size: 0,2 .. 1,5 mm²
solid, stranded or
solid, stranded or
solid, stranded or
ferrule
ferrule
ferrule
Impact protection rating IK02
Impact protection rating IK02
Impact protection rating IK02
*Designed according to IEC 61869-2. Excluding the rated output and burden values.
*Designed according to IEC 61869-2. Excluding the rated output and burden values.
*Designed according to IEC 61869-2. Excluding the rated output and burden values.
Specifications per type
Specifications per type
Specifications per type
RM17 RM17
RM17
Secondary
Secondary
0,5 mm2 0,75 mm2
0,5 mm2 0,75 mm2
Secondary
0,5 mm2 0,75 mm2
leads format*
leads format* 0,7 m 1,0 m
0,7 m 1,0 m
leads format* 0,7 m 1,0 m
Suitable for
Suitable for
Suitable for ø 5 mm
ø 5 mm
cable ø 5 mm
cable
cable
Approximate
Approximate
Approximate 10 g
10 g
weight
weight 10 g
weight
* To ensure a burden below 0,1 Ω at the end of the leads.
* To ensure a burden below 0,1 Ω at the end of the leads.
* To ensure a burden below 0,1 Ω at the end of the leads.
ELEQ reserves the right to carry out modifications on its products, in
ELEQ reserves the right to carry out modifications on its products, in
ELEQ reserves the right to carry out modifications on its products, in
order to improve them, without prior notice.
order to improve them, without prior notice.
order to improve them, without prior notice.

Safety instruction

Safety instruction
Safety instruction
All activities for installation, commissioning and maintenance
All activities for installation, commissioning and maintenance
All activities for installation, commissioning and maintenance
of this current transformer must be performed by qualified
of this current transformer must be performed by qualified
of this current transformer must be performed by qualified
personnel that have the knowledge of applicable safety
personnel that have the knowledge of applicable safety
personnel that have the knowledge of applicable safety
precautions. This guide assumes that the reader of this
precautions. This guide assumes that the reader of this
precautions. This guide assumes that the reader of this
document has sufficient electro-technical knowledge to
document has sufficient electro-technical knowledge to
document has sufficient electro-technical knowledge to
understand the content of this document.
understand the content of this document.
understand the content of this document.

General

General
General
The RM17 is a current transformer (CT) and can only be used
The RM17 is a current transformer (CT) and can only be used
The RM17 is a current transformer (CT) and can only be used
measuring electrical alternating currents. The RM17 is
measuring electrical alternating currents. The RM17 is
measuring electrical alternating currents. The RM17 is
suitable only for mounting on insulated primary conductors in
suitable only for mounting on insulated primary conductors in
suitable only for mounting on insulated primary conductors in
a weather protected and dry location.
a weather protected and dry location.
a weather protected and dry location.

Explanation of symbols

Explanation of symbols
Explanation of symbols
1,0 mm2 1,5 mm2
1,0 mm2 1,5 mm2
1,0 mm2 1,5 mm2
1,4 m 2,0 m
1,4 m 2,0 m
1,4 m 2,0 m
ELEQ b.v.
Tukseweg 130, 8331 LH Steenwijk, The Netherlands
+31 (0) 521 533 333
This product is designed according
This product is designed according
This product is designed according
EN-IEC 61010-1:2010 standards and therefore this
EN-IEC 61010-1:2010 standards and therefore this
EN-IEC 61010-1:2010 standards and therefore this
product meets the requirements of the Low Voltage
product meets the requirements of the Low Voltage
product meets the requirements of the Low Voltage
Directive 2014/35/EU.
Directive 2014/35/EU. Directive 2014/35/EU.
Read the installation guide before mounting the
Read the installation guide before mounting the
Read the installation guide before mounting the
product. Unprofessional work activities on electrical product. Unprofessional work activities on electrical
product. Unprofessional work activities on electrical
installations may result in a threat of danger to the life installations may result in a threat of danger to the life
installations may result in a threat of danger to the life
and health of human beings and livestock! and health of human beings and livestock! and health of human beings and livestock!
Under no circumstances the secondary circuit of the
Under no circumstances the secondary circuit of the Under no circumstances the secondary circuit of the
CT may be opened when the CT is mounted on a
CT may be opened when the CT is mounted on a CT may be opened when the CT is mounted on a
primary current and current is flowing in the primary
primary current and current is flowing in the primary primary current and current is flowing in the primary
circuit. High voltages may appear
circuit. circuit. High High voltages voltages may may appear appear
secondary leads when this circuit is left open.
secondary leads when this circuit is left open.
secondary leads when this circuit is left open.
RoHS Directive 2015/863/EU
RoHS Directive 2015/863/EU
RoHS Directive 2015/863/EU
ELEQ states that they only uses qualified component
ELEQ states that they only uses qualified component
ELEQ states that they only uses qualified component
in their products from manufacturers,
in their products from manufacturers,
in their products from manufacturers,
specifications meet or exceed the requirements of
specifications meet or exceed the requirements of
specifications meet or exceed the requirements of
the European Directive for the Restriction of use of
the European Directive for the Restriction of use of
the European Directive for the Restriction of use of
certain Hazardous Substances. certain Hazardous Substances.
certain Hazardous Substances.
WEEE Directive 2012/19/EU
WEEE Directive 2012/19/EU
WEEE Directive 2012/19/EU
The 'crossed out wheeled bin' symbol indicates that
The 'crossed out wheeled bin' symbol indicates that
The 'crossed out wheeled bin' symbol indicates that
the equipment should not be disposed as unsorted
the equipment should not be disposed as unsorted
the equipment should not be disposed as unsorted
municipal waste. Contact a qualified recycler for
municipal waste. Contact a qualified recycler for
municipal waste. Contact a qualified recycler for
disposal.
disposal.
disposal.
info@eleq.com www.eleq.com
84008
84008
84008
84008 / EN2006
RM17 Current Transformer
RM17 Current Transformer
RM17 Current Transformer
Installation Guide
Installation Guide
Installation Guide
to the
to the
to the
on the
on on the the
whose
whose
whose
RM17 RM17
RM17
Mounting Clip
Mounting Clip
Mounting Clip
Read this installation guide before installing the product
Read this installation guide before installing the product
Read this installation guide before installing the product
ELEQ b.v.
Tukseweg 130, 8331 LH Steenwijk, The Netherlands
+31 (0) 521 533 333 info@eleq.com
/ EN 2006
/ EN 2006
/ EN 2006
(4R17xx)
(4R17xx)
(4R17xx)
(411882)
(411882)
(411882)
www.eleq.com