Roland CompuRhythm CR-8000 Owner's Manual page 13

11
Ш Memory Back-up
The CR-8000 features a non-volatile
memory which will retain rhythm pro-
grams after switched off or discon-
nected. The CR-8000 relies on batteries
as a back-up circuit to protect these
memories.
The CR-8000 batteries must be replaced
once a year to ensure proper operation.
POWER
A
EE
9 To replace the three 1.5-Volt dry cell
batteries;
Connect the CR-8000 to socket and
switch is "ON" to protect its memo-
ries while replacing the batteries.
Open the battery cover on the bot-
tom of the CR-8000 body using a
coin or screwdriver.
Remove old batteries from the bat-
tery case. Always replace the entire
set of batteries.
Insert new batteries, making sure
that their polarities are correct as
indicated in the battery case.
Close the cover, insert and tighten
the retaining screw.
o
>
го
со
I
ол
BISYNCHRO INPUT/OUTPUT
Remember that the SYNC. In/Out
Select switch must be in the OUTPUT
position for the CR-8000 to operate by
itself.
. In case of operating CR-8000 by itself.
When CR-8000 operates by itself and
Sync. In/Out switch is in the INPUT
position, the CR-8000 can not function.
So be sure to set to the OUTPUT position
to operate by itself.
Pe
SYNCHRO-INPUT/OUTPUT
START/STOP
GND CLOCK
2. CR-8000 + other unit
CR-8000 other unit
SYNCHRO-INPUT OUTPUT
DIN cord
e In case of controlling CR-8000
by other unit |
The Tempo of other unit is displayed in the
LED display window of the CR-8000.
IN
дее | дер
OUTPUT
ein case of controlling other unit
by CR-8000
INPUT
u other =
CR-8000 НЫЙ
= |f the connected unit provides either only
SYNC OUT or IN, either of those examples
shown above applies to the case.