Table of Contents
Advertisement
PISTON REMOVAL AND CLEANING
MOVE THE PISTON TO ITS HIGHEST POSITION.
REMOVE THE LOCKING
NUT (ITEM 92) USING THE SPANNER WRENCH (ITEM 114).
INSERT THE
EXTRACTOR SCREW (ITEM 115) INTO THE SAME HOLE THE LOCKING NUT
WAS REMOVED FROM.
THE SPANNER WRENCH CAN AGAIN BE USED TO
SCREW THE EXTRACTOR SCREW DOWN UNTIL THE PISTON IS LIFTED
CLEAR OF THE TOP OF THE PISTON ROD.
AFTER REMOVING THE PISTON,
CLEAN OUT THE STUFFER CYLINDER WITH WARM WATER AND DETERGENT.
RINSE THOROUGHLY. TAKE CARE NOT TO DAMAGE THE COVER (ITEM 90)
AT THE BOTTOM OF THE CYLINDER.
PISTON
57
LOCKING NUT
PISTON
ROD
83
DRAIN
HOLES
9
EXTRACTOR SCREW---..
115
PAGE 6
SPANNER WRENCH
114
REMOVE SEAL AFTER
PISTON IS REMOVED
CLEAN GROOVE
AND
SEAL THROUGHLY
AND
LUBRICATE WITH HOLLY OIL
PRIOR TO REASSEMBLY
H-GASKET
56
PISTON-O RING
58
M-1260
Advertisement
Table of Contents
