Table of Contents
Advertisement
SET UP AND OPERATION
CAUTION:
KEEP THE MACHINE IN A VERTICAL POSITION
AT ALL TIMES INCLUDING WHEN UNPACKING.
1 .
ASSEMBLE CASTERS.
2.
CHECK THE VOLTAGE OF THE INCOMING ELECTRICAL SUPPLY.
CAUTION:
MAKE SURE THAT THIS VOLTAGE IS THE SAME
AS THAT INDICATED ON THE SERIAL NUMBER
PLATE ON THE BACK OF THE MACHINE.
3.
MOTOR ROTATION CHECK: SWING THE LID OPEN AND VERIFY THAT THERE
IS NOTHING INSIDE THE CYLINDER.
TURN THE PRESSURE CONTROL VALVE
ALL THE WAY IN.
START THE MACHINE BY PUSHING THE "ON" BUTTON ON
THE "ON/OFF" SWITCH AND PUSH THE KNEE LEVER TOWARD THE MACHINE TO
RAISE THE PISTON, AND PULL IT AWAY FROM THE MACHINE TO LOWER IT.
IF THE MOTOR IS FUNCTIONING, BUT THE PISTON IS NOT MOVING, THEN THE
MOTOR IS ROTATING IN THE WRONG DIRECTION.
CAUTION:
UNPLUG THE MACHINE FROM THE POWER SOURCE BEFORE
MAKING THE ELECTRICAL CHANGES NOTED BELOW.
REVERSE 3-PHASE MOTOR ROTATION BY INTERCHANGING ANY TWO OF THE INPUT
POWER LEADS AT THE POWER PLUG.
FOR SINGLE PHASE MOTORS, CHECK THE
WIRING DIAGRAM ON THE MOTOR ITSELF TO CHANGE THE PROPER CONNECTIONS
FOR ROTATION REVERSAL.
RESTART THE MOTOR AND OBSERVE THE PISTON RAISING
WHEN THE KNEE PEDAL IS PRESSED.
I
CAUTION:
DO NOT DISCONNECT THE GROUND LEAD.
4.
CLEANING:
CAUTION:
ALWAYS LOWER THE PISTON BEFORE
ATTEMPTING TO OPEN THE TOP COVER.
OPEN THE TOP COVER.
REMOVE THE PISTON AS ILLUSTRATED ON PAGE 6.
CLEAN THE INTERIOR OF THE CYLINDER, THE COVER, NOZZLES, TOP COVER
SEAL AND PISTON WITH WARM WATER AND DETERGENT.
BEFORE REASSEMBLY
LUBRICATE TOP COVER AND PISTON SEALS WITH HOLLY-LUBE FOR EASE OF
REASSEMBLY.
5.
OPERATION:
CAUTION:
THE TEMPERATURE OF THE PRODUCT BEING FILLED
SHOULD NOT BE BELOW 35.6 DEGREES FAHRENHEIT
WITH THE PISTON LOWERED, PLACE THE MEAT IN THE MACHINE, WELL-BALANCED,
WITHOUT EMPTY SPACES AND AIR POCKETS (AIR POCKETS TEND TO DAMAGE THE
SAUSAGE CASING).
CLOSE THE TOP COVER.
THE MACHINE IS NOW READY FOR
OPERATION. PRESS THE KNEE LEVER TOWARD THE MACHINE TO THE RIGHT;
IF THE MEAT COMES OUT TOO FAST, REDUCE THE SPEED BY TURNING THE
PRESSURE CONTROL KNOB (ITEM 74, PAGE 11) COUNTERCLOCKWISE; IF TOO
SLOW, TURN THE PRESSURE CONTROL KNOB CLOCKWISE TO INCREASE THE SPEED.
HAVING EMPTIED THE CYLINDER OF MEAT, PULL THE CONTROL LEVER ON THE
LEFT TO LOWER THE PISTON.
IT IS NOT NECESSARY TO HOLD THE CONTROL
LEVER.
THE PISTON WILL FULLY RETRACT AUTOMATICALLY.
WHEN THE
PISTON IS ALL THE WAY DOWN, PUSH THE CONTROL LEVER TO NEUTRAL
BEFORE LOADING MEAT.
OPEN THE LID AND RELOAD THE CYLINDER WITH MEAT.
PAGE 5
M-1721
Advertisement
Table of Contents
