Vixen Horns VXC8301PROBDP Installation Manual

BEFORE BEGINNING YOUR INSTALLATION

Read through the instruction guide before getting started with the installation. Professional installation is recommended for
this product.

CONTENTS

 200 PSI Air Compressor (Black) x 2
 3/8" NPT Stainless Steel Braided Leader Hose with Check Valve x 2
 170-200 PSI Pressure Switch x 1
 Intake Air Filter with Remote Installation Kit (10 FT Hose) x 2
 4-PIN 12V/40A Relay with Pre-wired Plug x 2
 40A In-line Fuse with Waterproof Holder x 2
 60A In-line Fuse with Waterproof Holder x 1
 Mounting Hardware
The specific voltage requirement for these compressors is 12 volt DC, therefore installation must be done to a
DC power source of 12 volts.

SAFETY INSTRUCTIONS

 Do not attempt to disassemble, repair or customize this product.
 Avoid setting up any parts of this product where there is a risk of falling off or risk of coming in contact with water.
 Avoid reaching out to touch or pick up any fallen or water submerged parts.
 Never leave this product unattended during use.
 Intended for use by adults only.
 During and immediately after use, avoid touching any part of the compressor with bare hands as it is very hot
during such periods.
 Avoid use of product near flames, explosive materials, aerosol products or oxygen devices.
 Be sure to pump nothing other than atmospheric air.
 Air sprayer or nozzle should always be pointed away from any part of the body.
 The compressor has Thermal Overload Protection, if this protection activates, cut off the source of power and let
the unit cool down for about 30 minutes. This will reset the system and allow you to safely resume use of the air
compressor.
 Make sure your battery ground is detached before you begin.

Never use in areas with poor
 Employ equipment for eye protection during drilling operations.
 Ensure that your air system has no pressure before you begin.
ventilation.
PAGE 1 of 4
VXC8301PROBDP
INSTALLATION GUIDE