Advertisement
BEFORE BEGINNING YOUR INSTALLATION
Read through the instruction guide before getting started with the installation. Professional installation is recommended for
this product.
CONTENTS
15 PSI Compact Air Compressor (Black)
Mounting Hardware
The specific voltage requirement for this compressor is 12 volt DC, therefore installation must be done to a DC
power source of 12 volts.
SAFETY INSTRUCTIONS
Make sure you never attempt to disassemble this horn kit's electrical components.
Never use your bare hands to any part of the compressor immediately after or during use.
Avoid operating this product in an area with risk of falling or submergence into a liquid (water).
Do not reach out for or touch any component that has fallen or been submerged into water.
Make sure you set up in areas with good ventilation.
Make sure your battery ground is detached before getting your installation started.
Employ equipment for eye protection during drilling operations.
COMPRESSOR MOUNTING
The ideal location for the compressor to be installed is a dry area inside your engine compartment where it
will be safe from exhaust and engine manifold heat.
To make the compressor firm and secure, drill a hole of 3/16". IMPORTANT: The compressor must be
mounted vertically (with air exhaust port on top).
Install the bolt's head into the compressor housing's slot. Tighten the compressor firmly to the vehicle with the
provided lock washer and nut.
PAGE 1 of 2
VXA7211B
INSTALLATION GUIDE
Advertisement
Table of Contents
Related Manuals for Vixen Horns VXA7211B
Summary of Contents for Vixen Horns VXA7211B
- Page 1 VXA7211B INSTALLATION GUIDE BEFORE BEGINNING YOUR INSTALLATION Read through the instruction guide before getting started with the installation. Professional installation is recommended for this product. CONTENTS 15 PSI Compact Air Compressor (Black) Mounting Hardware The specific voltage requirement for this compressor is 12 volt DC, therefore installation must be done to a DC power source of 12 volts.
- Page 2 VXA7211B INSTALLATION GUIDE AIR LINE INSTALLATION Connect one side of the airline to the compressor’s air exhaust port and the other side to your horn’s air intake port. For optimal performance use the shortest length of airline possible.
Need help?
Do you have a question about the VXA7211B and is the answer not in the manual?
Questions and answers
Were do I wire the solenoid mounted to my horns
Wire the solenoid relay as follows for the Vixen Horns VXA7211B:
- Connect relay PIN 30 and PIN 86 to a 12-volt positive source (battery, alternator, or other).
- Use a 16-gauge wire or heavier.
- Protect the circuit with a 20A fuse (not provided).
- One terminal of the horn button connects to the relay, and the other terminal grounds to bare metal using an 18-gauge wire or heavier.
This answer is automatically generated