Advertisement
Things to Remember
• Water enters only during the defrost cycle. Therefore the first cycle will be completed without water
in the system.
• As the room and water temperatures
operating temperatures
will result in reduced ice production .
• The unit will shut off when ice in the storage
automatically
cycle to keep the bin full.
• The storage bin is not refrigerated
temperature.
Oiling
All components
of the ice maker are lubricated at the factory and should not require any additional
oiling for the normal life of the machine.
Filtering and Treating Water
In some areas it may be beneficial to filter or treat the water being supplied to the ice machine to
reduce water system maintenance
type of ice.
For information
on filtering
Agency.
Light Replacement
To replace the light bulb (G.E. #912, 12.8V) remove the grid cover at top of ice bin by removing thumb
screws. Bulb is located behind grid cover. Replace bulb and grid cover.
Cleaning Exterior Surfaces
Cabinets may be cleaned simply by wiping with a damp cloth.
Door Gasket
The vinyl gasket strip around the inside of the door keeps the door sealed. Wash it regularly with a
solution of warm water and detergent. Rinse thoroughly and dry.
Toe Space Plate
Do not block the toe space plate at bottom of unit. Obstruction of airflow could result in malfunction.
is recommended
this toe plate be vacuumed periodically.
Cleaning and Sanitizing the Ice Making System
vary, so will the amount of ice produced. This means that high
bin touches
and some meltage will occur. This, too, varies with the room
(cleaning and removal of scale deposits) and to produce the best
and treating
the water see your local plumber or Authorized
the bin thermostat
well and will
Service
It
Advertisement
