Operation - Commercial Electric AK366B-MBK Use And Care Manual

Operation

WALL CONTROL OPERATING INSTRUCTIONS
NOTE: The wall control has been pre-paired in the factory for
your convenience.
NOTE: On each start up of your ceiling fan, the fan blades will
oscillate back and forth. This is a NORMAL OPERATION for DC
motor ceiling fans as they go through a calibration cycle. The
fan is NOT DEFECTIVE.
Your DC brushless motor is equipped with an automatically learned
type wall control. There are no frequency switches on the receiver or
transmitter. The fan can start to use once the pairing process is done.
1. 1, 2, 3, 4, 5 and 6 button - These six buttons are used to set the
fan speed as follows:
1 = minimum speed
2 = low speed
3 = medium low speed
4 = medium speed
5 = medium high speed
6 = high speed
2. Power on/off: This button will activate the fan and light when
the fan and light are both off.
3.
Reverse button: This button is to control fan direction. This
button must be pressed while fan is running (suggested speed 4).
4. Press and release the
CCT
temperature options:
Option 1: 3000K (Soft White)
Option 2: 4000K (Bright White)
Option 3: 5000K (Day Light)
CCT
5. Light on/off and dimming button: Press and release this
button to turn the light on or off. Press and hold the button to
activate the dimming function.
6. AC Power On/Off tab: Pull up the tab to turn the AC power
off.
button to cycle through three color
LEARNING PROCESS
IMPORTANT: If you have two or more fans, please follow
steps below to control each fan independently. Also follow
steps below to re-pair the wall control and the receiver when
needed.
Within 30 seconds of turning AC power on, press and hold the
"LEARN" button for about 5 seconds and release. If optional light
kit is installed, the light kit will ash twice and the signal light on
the wall control will come on when the button is pressed. The fan
has completed the pairing process with the wall control and is
ready for use.
NOTE: A single fan can be controlled with as many as 3 wall
controls in one room. Every control will need to repeat the
pairing process based on instructions above and all controls
must be within 30 feet of the fan.
L
LEARN
Signal light
15
Please contact 1-833-HDFANS-1 / (1-833-433-2671)
CCT
Power on/off
CCT
AC Power On/Off
HOMEDEPOT.COM
for further assistance.