Forced Operation - LG VA123HL NBO Owner's Manual

Operating Instructions

Forced operation

Forced operation is used when the remote controller can't be used. The operation will be started if the ON/OFF
button is pressed. If you want to stop the operation, re-press the button.
Premium type
ON/OFF
button
Cooling Model
Operating mode Cooling
Indoor FAN Speed
Setting Temperature
Test operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room temperature
and resets in 18 minutes. During test operation, if remote controller signal is received, the unit operates as remote controller
sets. If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound 1
'beep'. If you want to stop the operation, re-press the button.
NOTE
If you do not have the remote controller around here, you can start to operate the forced operation.
If you force to close the front panel, some parts may be damaged.
So you must follow the below step. (Only premium type)
• In case of turning ON
Open the front panel.
• In case of turning OFF
Open the front panel.
20 Air Conditioner
Room Temp. ≥ 24°C
Cooling
High High
22°C 22°C
Press the ON/OFF button.
So you can operate the air
conditioner.
Press the ON/OFF button.
So you can turn off the air
conditioner.
Rational type
Heat pump Model
21°C ≤ Room Temp. < 24°C
Healthy Dehumidification
High
23°C
➀ Lift up the front panel
after approximately 25
seconds.
➁ Fold the supporter.
➂ Close the front panel.
Fold the supporter after
approximately 25 seconds.
Close the front panel.
ON/OFF
button
Room Temp. < 21°C
Heating
High
24°C
Press the front panel as
shown until hearing
"clicking" sounds.
Press the front panel as
shown until hearing
"clicking" sounds.