Table of Contents
Advertisement
NLTroubleshooting
Malfunction
Drying time is too long.
Water is leaking.
Laundry is too damp.
44
Cause and Troubleshooting
Perform simple device maintenance on the device.
▶
→ "Device care", page 36
Automatic self-cleaning rinses the heat exchanger of
the device.
No malfunction.
1.
Do not pull out the condensed water container.
2.
Do not abort the program.
3.
The appliance is not leveled properly.
→ "Adjusting the device", page 16
▶
Water drain hose is not connected correctly.
Make sure that the water drain hose is correctly
▶
connected.
→ "Connect the water drain hose", page 14
Unsuitable program for the type of fabric set.
Set a time program for post-drying.
▶
→ "Programs", page 26
Power supply has failed.
Check whether the interior lighting or other devices
▶
are working.
The load amount is too high.
Observe the maximum load quantity of the
▶
→ "Programs", page 26 .
Warm laundry feels damper than it actually is after
the end of the programme.
Remove the laundry from the drum immediately after
1.
drying.
Spread out the items to let them cool.
2.
Unsuitable drying target set.
→
"Change dryness target", page 25 .
▶
Drying target not adjusted.
→ "Adjust dryness target", page 25 .
▶
Load quantity too little.
Set a time program for post-drying.
▶
→ "Programs", page 26
Humidity sensor contaminated.
→ "Clean humidity sensor", page 39 .
▶
Drying process aborted and condensed water container
filled.
→ "Empty the condensed water container", page 33 .
1.
Advertisement
Table of Contents
