Table of Contents
Advertisement
NLTroubleshooting
Malfunction
Drying time is too long.
Water is leaking.
Laundry is too damp.
40
Cause and Troubleshooting
→ "Open base unit", page 33 .
1.
Clean heat exchanger.
2.
→ "Cleaning the bottom unit", page 34
→ "Close base unit", page 35 .
3.
The appliance is not leveled properly.
→ "Adjusting the device", Page 14
▶
The seal of the heat exchanger cover is dirty.
Clean the seal of the heat exchanger cover.
▶
→ "Cleaning the filter system of the bottom unit",
page 29
Water drain hose is not connected correctly.
Make sure that the water drain hose is connected
▶
correctly.
Handle of the heat exchanger cover not closed
correctly.
Make sure that the heat exchanger cover handle is
▶
properly closed.
→ "Close base unit", page 35
Inappropriate program set for the type of fabric.
Set a time program for post-drying.
▶
→ "Programs", Page 22
Power supply has failed.
Check whether the interior lighting or other
▶
appliances are working.
The load quantity is too high.
Pay attention to the maximum load of the
▶
→ "Programs", Page 22 .
Warm laundry feels damper than it actually is after
the program has ended.
Remove the laundry from the drum immediately after
1.
drying.
Spread out the items to let them cool.
2.
Inappropriate drying target set.
→
"Change drying target", page 21 .
▶
Drying target not adjusted.
→ "Adjust drying target", Page 21 .
▶
Loading quantity too little.
Advertisement
Table of Contents
