Table of Contents
Advertisement
+
Water softening
system / special salt
To ensure good rinsing results, the
l t
s y s t e m / s p e c i a l s a
W a t e r s o f t e n i n g
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l) must
be softened. The water is softened with
special salt (regeneration salt) in the
water softening system
of the dishwasher. The setting and
therefore the required amount of salt
depends on the degree of hardness of
your tap water (see following water
hardness table).
Water hardness table
Water softening system/special salt en
Adjusting the water softening
system
You can set the amount of salt that
should be added to a value between
•:‹‹ and •:‹ˆ. No salt is needed with
the setting •:‹‹.
Here's how to set up the amount of
added salt:
Ask your local water utility company
1.
for the water hardness value of the
tap water.
Required setting can be found in the
2.
water hardness table.
Switch on ON/OFF switch (.
3.
Hold down the programme button
4.
# and then repeatedly press the
START button ` until •:‹...
appears in the display window.
Release both buttons.
5.
The LED of the # button flashes
and the digital display h shows
the factory setting •:‹....
Press the programme button 3.
6.
Each time the button is pressed, the
set value increases by one level;
when it reaches the value •:‹ˆ the
display jumps back to •:‹‹ (Off).
Press START button `.
7.
The chosen setting has now been
stored in your dishwasher.
13
Advertisement
Table of Contents
