BMW 4 Series 2023 Owner's Manual page 298

Table of Contents

Advertisement

MOBILITY
4.
Unscrew the valve cap from the wheel and
screw the connecting piece of the filler hose
onto the valve.
5.
With the compressor switched off, insert the
connector into the power socket in the vehi-
cle interior.
Filling the tire with sealing
compound
Safety information
DANGER
If the exhaust pipe is blocked or ventilation is
insufficient, harmful exhaust gases can pene-
trate the vehicle. The exhaust gases contain
pollutants which are colorless and odorless.
In enclosed areas, exhaust gases can also
accumulate outside of the vehicle. There is a
danger to life. Keep the exhaust pipe free and
ensure sufficient ventilation.
NOTICE
The compressor can overheat during ex-
tended operation. There is a risk of damage
to property. Do not run the compressor for
more than 10 minutes.
Filling the tire with sealing compound
1.
With standby state or drive-ready state
switched on, switch on the compressor.
298
Wheels and tires
Online Edition for Part no. 01405A7D166 - II/23
Let the compressor run for max. 10 minutes
to fill in the tire sealant and reach a tire
pressure of 2.5 bar/36 psi.
While the tire is being filled with tire sealant,
the tire pressure can briefly reach approx.
6 bar/87 psi. Do not turn off the compres-
sor in this phase.
2.
Switch off the compressor.
Checking the tire pressure
Read the tire pressure on the tire pressure dis-
play of the compressor. The tire pressure must
be at least 2.5 bar/36 psi.
Tire pressure too high
If the tire pressure is too high, reduce the tire
pressure with the pressure reducing valve on
the compressor.
Minimum tire inflation pressure is not
reached
Do not continue driving unless a minimum tire
pressure of 2.5 bar/36 psi is reached. Contact
an authorized service center or another quali-
fied service center or repair shop.
Minimum tire inflation pressure is
reached
1.
Pull the connector out of the socket in the
vehicle interior.
2.
Disconnect the hose from the sealant bottle
and the valve on the wheel.
3.
Screw the valve cap onto the valve.
OwnersManuals2.com

Advertisement

Table of Contents
loading

Table of Contents