Table of Contents
Advertisement
▷
Each time the rocker switch is tapped to the
resistance point, the set speed increases or
decreases by 1 mph/1 km/h.
▷
Each time the rocker switch is pressed
past the resistance point, the desired speed
changes by a maximum of 5 mph/10 km/h.
Hold the rocker switch in position to repeat the
action.
Adjusting the distance
Safety information
Warning
The system cannot serve as a substitute for
the driver's personal judgment. Due to the
system limits, deceleration can be late. There
may be a risk of accidents or risk of dam-
age to property. Be aware to the surround-
ing traffic situation at all times. Adjust the
distance to the traffic and weather conditions
and maintain the prescribed safety distance,
possibly by braking.
Reducing the distance
Press the button repeatedly until the
desired distance is set.
Instrument cluster will display selected dis-
tance.
Increasing the distance
Press the button repeatedly until the
desired distance is set.
Instrument cluster will display selected dis-
tance.
Automatic adaptation of the distance
Depending on the equipment and national-
market version: the system can be set so that
the distance to the vehicle in front is automati-
cally adjusted within the set distance. The sys-
Driver assistance systems
Online Edition for Part no. 01405A7D166 - II/23
tem takes into account the traffic situation and
ambient conditions, e.g. poor visibility.
1.
Apps menu
2.
"Vehicle apps"
3.
"Driving settings"
4.
"Driver Assistance"
5.
"Driving"
6.
"Speed Limit Assistance"
7.
"Situational distance control"
Continuing cruise control
An interrupted cruise control can be continued
by calling up the stored speed.
Make sure that the difference between current
speed and stored speed is not too large be-
fore calling up the stored speed. Otherwise,
unwanted vehicle deceleration or acceleration
may occur.
Press the button on the steering wheel with
the system interrupted:
With Steering Assistant.
Without Steering Assistant.
Cruise control is continued with the stored val-
ues.
In the following cases, the stored speed value
is deleted and cannot be called up again:
▷
When the system is switched off.
▷
When drive-ready state is switched off.
CONTROLS
209
OwnersManuals2.com
Advertisement
Table of Contents
