Timer Setting - AES Proteam iX7 Manual

6.3 TIMER SETTINGS
6.3.1 Setting the Timer
There are 3 groups of Timers in this controller. In the main interface, press
" " to enter into Timer settings. You will see the number of group "1" is
flashing, press "
indicates which group of Timer ON you are setting. Then press "
" to increase or decrease values. After setting the Hour digit, you can
press "
completed, press "
are flashing. Then do the same way as above to set the Hour and Minute
digits of Timer OFF
Press
"
In the main interface, press "
press "
For example:
Automated Environmental Systems, Unit B, Anglian Lane, Bury St Edmunds, IP32 6SR
01284 6587710 | sales@automatedenvironmentalsystems.co.uk
Press "
to save and
exit.
" again , the Hour digit and "
" again to set the Minute digit. When the settings of Timer ON
" and you will see the Hour digit and icon "
1
, now the 1
to save and go back to the main interface.
"
" or " " to switch to set different groups of Timers.
"
st
group of Timer is set successfully. Then
" to enter into Timer settings, then you can
- 19 -
" are flashing, it
" or "
1
"