Advertisement
VACUUM BREAKER INSTALLATION
1
- Remove complete trim from vacuum breaker valve.
- Install bidet elbow into threaded outlet.
2
- Insert gasket into bidet wye and thread onto bottom of vacuum
3
breaker valve.
- Remove black plastic lock nut, nylon slip washer and one
4
black self-seating china seal.
- Insert diverter valve body up from below and reinstall black
5
self-seating china seal, nylon slip washer and black plastic lock
nut being sure to tighten firmly by hand.
- Thread trim cylinder onto vacuum breaker valve and tighten
6
firmly. Place handle on top and secure with brass screw. Insert
handle cap with arrow facing towards front of bidet.
HANDLE TRIM INSTALLATION
DO NOT DISASSEMBLE HANDLE ASSEMBLY - DROP-IN VALVES
- Remove the valve body mounting hardware from valve body.
1
Hot valve assembly "Red" to be mounted on left. Cold valve
assembly "Blue" to be mounted on right.
- Apply a ring of silicone caulking around the handle hole on
2
bidet top. DO NOT USE PLUMBERS' PUTTY, WHICH CAN
DAMAGE FINISH.
- Slip valve through appropriate hole on top of bidet. Reinstall
3
valve body mounting hardware, fiber washer and valve body
locknut. Align handles with respect to the bidet, and tighten valve
body locknut until secure.
- Aim outlet hoses towards bidet wye and attach securely to
4
avoid leakage.
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
Handle Cap
Screw
Handle
Trim Cylinder
Black plastic lock nut
White Nylon Slip Washer
Black Soft Seating China Seals
Black Soft Seating China Seals
2/6
Advertisement
