Before Using For The First Time; Filling The Tank; Adjusting The Temperature And Steam - TEFAL ULTIMATE STEAM POWER Manual

1800133458 FV96XX E0_110x154 11/07/14 13:09 Page2
Description
1. Spray
2. Cover for filling tank
3. Steam control
4. Anti-calc valve
5. Anti-calc valve release button
6.
Turbo steam button
7. Auto-Stop safety light
8. Power cord
Read the instructions for
use carefully.
Remove any labels from
the soleplate before
heating the iron.
Preparation
What water to use?
• Your appliance has been designed to function with untreated tap water. However, it is necessary to operate the
Self-Clean function regularly in order to eliminate hard water deposits from the steam chamber.
• Types of water not to use: Heat concentrates the elements contained in water
during evaporation. The types of water listed below may contain organic waste,
mineral or chemical elements that can cause spitting, brown staining or
premature wear of the appliance: water from clothes dryers, scented or softened
water, water from refrigerators, batteries, air conditioners, rain water, boiled,
filtered or bottled water. Do not use pure distilled nor pure demineralised water.
These types of water should not be used in your TEFAL iron.
Do not exceed the tank's
MAX marking. Do not fill
your iron directly under the
tap.
Do not remove the anti-calc
valve to fill the tank.
Use

Adjusting the temperature and steam

• Adjust the thermostat control – fig.4, by referring to the table below.
• The light comes on. It will go out when the soleplate is sufficiently hot – fig.5.
FABRIC
LINEN
COTTON
WOOL
SILK / SYNTHETIC (Polyester,
Acetate, Acrylic, Nylon)
RECOMMENDATIONS
• Your iron heats up quickly: start with fabrics that require a low heat, then finish
with those that need higher temperatures.
• If you lower the thermostat, wait for the light to come back on before starting to
iron again.
(depending on model)

Before using for the first time

• Before using your iron for the first time in the steaming position, we
recommend that you let it function for a few moments in the horizontal
position and away from your clothes. Press the turbo steam button several
times in this position.
• On first use you may notice a small amount of smoke and odour or a small
discharge of particles. This is normal and will quickly disappear.
• Unplug your iron before filling it.
• Set the steam control to
• Hold the iron in one hand and tilt it slightly, pointing the soleplate upwards.
• Open the tank cover – fig.2.
• Fill the tank to the "MAX" marking – fig.3.
• Close the tank cover.
POSITION OF THERMOSTAT
CURSOR STEAM SETTING
MAX
•••
••
•
= STEAM ZONE
2
9. Easycord system
10. Thermostat light
11. Extra-stable heel
12. Spray trigger
13. Thermostat control
14.
Gliss/Glide Protect TM Autoclean soleplate
(depending on model)
If your water is very hard,
you are able to mix 50%
untreated tap water with
50% store bought distilled
water.

Filling the tank

– fig.1.
According to the type of fabric
selected, your iron automatically
and accurately determines the
temperature and steam flow, to
guarantee the best result.