Handset Instellingen; Alarm (Alarm Function); Ring Tones Handset; Handset Tones - Profoon PDX-8400 User Manual

Refer to the user manual of your home or office switchboard or consult
your carrier concerning the desired interruption time. 100 ms is the
standardized interruption time, and this time is set at the factory.
CHANGE PIN:
You can change the PIN code, which you need with registering and
deregistering of (new) handset, with [CHANGE PIN]. The factory PIN
code is 0000.
See chapter 13 (forget PIN code), in case you have lost or forgotten
the new PIN code.
ECO MODE:
When setting the ECO Mode to ON, you decrease the transmitting
power of the handset and base. This results in a lower emission, but
also a shorter range (+/- 50%).

10.4 Handset Instellingen:

Alarm: (alarm function)
You can set the phone to sound an alarm tone during 45 seconds at
a preset moment (or press any key to switch off the signal prema-
turely).
Select ON to enable this function, and enter the alarm time through
the keyboard (24 hour system). After this, you can enable or disable
the snooze function (7 minutes snooze).The alarm must be reset
daily.

Ring tones handset:

Select the option [ RING SETUP ] to set the ring tones of the handset:
• You can set different melodies for intercom calls and calls from
outside.
• At [ INT. RING ] and [ EXT. RING ], you can choose from 10 differ-
ent melodies.
• At [ RING VOLUME ], you can choose from 5 volume levels and
'volume-off'.

Handset tones:

You can enable or disable the following tones through the option
[ TONE SETUP ]:
• [ KEY TONE ]: the tones that sound when you press a key.
• [ BATTERY TONE ]: the tones that sound when the batteries are
low.
• [ OUT OF RANGE ]: the tones that sound when you get out of
reach.
-18-